Getting Started

Start here

The order to build a DCC layout in, from bare track to trains that report where they are, with a guide for each stage.

What this guide is for

Getting Started takes you from a length of track to a working DCC layout, one stage at a time. Each stage ends with something you can run and test before you move on to the next.

What it does

  • Gives you an order to work in, so each job builds on the one before.
  • Shows the wiring one step at a time. The step-by-step guides draw each wire as you go, so you can follow along at the baseboard.
  • Uses real equipment as its examples: a YaMoRC YD7010 command station, DCC Concepts Cobalt point motors, Train-Tech signals and YaMoRC YD6016LN detectors. The ideas carry over to other makes.

What it doesn't do

  • Replace the instructions that came with your equipment. Where they say something different, follow the manufacturer.
  • Cover baseboards, track planning or scenery.
  • Claim to be the only way to wire a layout. It is one way, kept as simple as we can make it.
  • Cover every make and model. If yours isn't one of the examples, the stages still apply; the terminals and buttons will differ.

The five stages

  1. Setting up the track

    Lay the track and get it running smoothly by hand before any electronics go in. Decide now where the points go and where you will want to know a train's position: rails are far easier to cut and wire before the track is ballasted.

    A guide for this stage is on its way.

  2. Connecting DCC

    Connect a command station to the track. Its two track wires split into a power bus, which feeds the rails through droppers, and an accessory bus for the point motors and signals to come.

    Set up a command stationDCC wiringTrack and bus wiring

  3. Setting up a loco

    Put one loco on the track, give it an address of its own and drive it. Get one running well before you add more.

    Set up a loco

  4. Adding accessories

    Fit point motors and signals, connect each to the accessory bus and give it a number, so it can be worked from your controller.

    Accessory controlPoint motorsSignals

  5. Block detection

    Divide the track into sections and connect each to a detector, so the layout can report which sections have a train in them. Signalling and automation are built on this.

    Block detectionYD6016LN-CS detectorYD6016LN-RC detector

With the layout running, Lighting and Sound are where to go next.

← Back to the glossary